Electrical Panel Upgrade and Replacement in Saint George, UT

Your electrical panel sets the limit on everything else in the building. If you are adding an EV charger, a heat pump, a hot tub or a finished basement, or if the breaker box is decades old, an electrical panel upgrade in Saint George gives you the capacity and the protection modern loads need.

Call (888) 633-7804Same-day service, 24/7 emergency response

Electrical panel upgrade in Saint George, UT: what we handle

KITMUND replaces worn-out breaker boxes and fuse boxes and upgrades 100 amp services to 200 amps for homes and businesses in Washington County. We size the new panel with a load calculation, coordinate the disconnect with the utility, and label every circuit clearly before we leave.

200 amp panel upgrade

The standard for modern homes, with room for EV charging, electric heating and cooling, and future circuits.

100 amp to 200 amp upgrade

New meter base, service conductors, grounding and main panel sized for a real load calculation.

Breaker box replacement

Outdated, recalled or damaged panels swapped for a new load center with matching breakers.

Fuse box replacement

Screw-in fuse panels replaced with breakers, plus the grounding and bonding older homes often lack.

Sub panel installation

A feeder and sub panel for a garage, shop, addition, basement or detached building.

Main panel repairs

Burnt bus bars, corroded lugs and loose neutrals corrected, or the panel replaced when repair is not worth it.

Signs you need an electrical panel upgrade in Saint George

The panel is full and circuits are doubled up on breakers
Breakers trip when the dryer, oven and air conditioning run together
The panel is warm, rusty, buzzing or smells hot
You still have screw-in fuses or a 60 or 100 amp service
You are planning an EV charger, hot tub, addition or all-electric appliances

Why it matters in Saint George

In Saint George, cooling is the largest electrical load by far, and many homes also run pool equipment, RV hookups and casitas. We size panels and circuits for peak summer demand in Washington County and use equipment rated for outdoor heat and sun.

Homeowners and businesses in Saint George call (888) 633-7804 for an electrical panel upgrade they can count on.

How our electrical panel upgrade service works in Saint George

Call (888) 633-7804
Tell us what is happening or what you want installed. We ask a few questions and book a time, or send someone straight away if it is urgent.
We look and explain
The electrician inspects, tests and tells you in plain words what is needed and what it will cost before work starts.
We do the work
Neat, code-correct work with floors and furniture protected. Permits and inspections are arranged where the local jurisdiction requires them.
We test and walk you through it
Everything is tested and labeled, the work area is cleaned, and we show you what was done.

Electrical panel upgrade near me: Saint George and nearby towns

Our electricians work in every part of Saint George, including Bloomington, Bloomington Hills, Little Valley, Green Valley, Dixie Downs, SunRiver, Stone Cliff, Tonaquint, Sunbrook, The Ledges and Downtown St. George. Whether you searched for electrical panel upgrade near The Ledges or an electrician in Downtown St. George, you reach the same crew at the same number. Saint George is also known as St. George, and we serve it under either name. Nearby communities we travel to from Saint George include Santa Clara (about 4 mi), Washington (about 5 mi), Ivins (about 6 mi), Dammeron Valley (about 13 mi), Gunlock (about 15 mi) and Leeds (about 16 mi).

Electrical panel upgrade questions in Saint George

What does an electrical panel upgrade cost in Saint George?

It depends on the amperage, whether the meter base and service conductors must be replaced, where the panel sits, and what the local utility and building department require. Call (888) 633-7804 and we will look at your panel and give you a written quote for your Saint George property.

How long is the power off during a panel replacement?

Most residential panel swaps are done in one working day, with power off for part of it. We schedule the utility disconnect ahead of time so you know the window.

Do I need 200 amps?

If you heat or cool with electricity, charge a vehicle at home or plan to add large loads, 200 amps is usually the right size. We run a load calculation so the answer is based on your house, not a guess.

Does a panel upgrade in Saint George need a permit?

Service changes generally require a permit and inspection from the local jurisdiction. We handle the paperwork and meet the inspector.

More electrician services in Saint George, UT

People find this service by searching for electrical panel upgrade Saint George, electrical panel replacement Saint George, 200 amp panel upgrade Saint George, 100 amp to 200 amp upgrade Saint George, breaker box replacement Saint George, fuse box replacement Saint George, main panel upgrade Saint George, sub panel installation Saint George, electrical panel upgrade cost Saint George and service upgrade electrician Saint George.

Talk to an electrician now

Electrical panel upgrade in Saint George, UT. Call (888) 633-7804 for fast service, 24/7.

Call (888) 633-7804